Advertisement

7 Steps to Keeping your Outboard Kicking

Ed Sherman takes us through 7 steps to keeping the outboard running like a champ.

crw0111_sherman01.jpg

winterizing an outboard motor Gretchen Thor

crw0111_sherman02.jpg

Remove the screw-in plug for the water flush and insert a hose adapter, then run your engine with the fuel stabilizer added to your fuel. If your engine doesn’t have a flush port, use an engine flusher (looks like ear muffs) Gretchen Thor

crw0111_sherman03.jpg

winterizing an outboard motor Gretchen Thor

crw0111_sherman04.jpg

After removing the top gear-case plug you should see gear oil slowly seep from the access hole. If not check your levels by using a matchstick or a pipe cleaner inserted into the hole, at the same time you can check for any signs of water mixing with the oil; it will show as a milky white color and indicates a lower-unit seal leak that must be attended to immediately by a qualified mechanic. Gretchen Thor

crw0111_sherman05.jpg

Lubricate the engine tilt and steering points. Gretchen Thor

crw0111_sherman06.jpg

Make sure you check for engine corrosion, if the sacrificial anodes are correded more than 50% they should be replaced. Gretchen Thor

crw0111_sherman07.jpg

After removing the spark plugsspray the fogging oil into each cylinder for a few seconds, preferably while turning the engine over with teh pull-start cord. Gretchen Thor

crw0111_sherman08.jpg

winterizing an outboard motor Gretchen Thor

crw0111_sherman09.jpg

winterizing an outboard motor Gretchen Thor

crw0111_sherman010.jpg

Inspect the propeller for dings and dents. Gretchen Thor

crw0111_sherman012.jpg

Four Strokes: Tilting the engine up to it’s maximum will help drain the old oil with the least amount of mess. Gretchen Thor

outboard maintenance polish

After all of the maintenance is done a good wax job finishes up the project. Gretchen Thor
Advertisement
Advertisement